Procedure to make RAMMER ＲＶ６０

　1. Download the file and print out on an optional paper.

　2. Carefully cut off an outward form by a cutter knife, etc.

　3. Lightly trace the bend portion with something, the edge of which is sharpened and then crease. Be careful, the paper will be torn if you would trace strongly.

　4. If you color which is similar to each part to the end of the cut out portion by a colored pencil, etc., the stuck portion will not be noticeable.

　5. For the part (1) which connects an engine and a fuel tank, make a cut in the part of the engine and glue it firstly. After that, assemble the engine part ( see the photos）

　6. Assemble the each part and glue every part which has the same symbol.

　7. For the part (2), do not make a mistake for the front and the back. (Lower height portion is the front.)

　8. Carefully assembly a striking plate so as not to warp.

　9. Complete referring to the completion picture.

◇◆Pay special attention whenever you use a cutter knife or a cutting tool.◆◇