Making procedure of Macadam Roller R2-1

　1. Download the file and print it out on an optional paper.

　2. Carefully cut an outward form off by a knife, etc.

　3. Lightly trace the bend portion by a thing with a sharp point and crease.
　　　If you would trace the paper strongly, the paper would be torn.

　4. If you would paint with a close color to the cutting end of each part by a
　　　colored pencil, the stuck parts will not be noticeable.

　5. Assemble the steel wheel and the part:
　　　　As the adhesive parts of a mirror and a pipe are very small, be careful so as not to tear.

　6. Assembling and glue of the body:
　　　　 Assemble the body.
　　　　 Glue the parts 「relating to a driver's seat」 to 「the body」.（See a photo）
　　　　 Glue the parts for 「underneath of the seat」 at right and left, and install 「the seat」
　　　　　　（See a photo）

　7. Assembling and glue of the rear frame:
　　　　 Assemble the rear frame.
　　　　 Making sure the position of putting the steel wheel in, glue 「a fender for rear wheel」

　8. Making sure the position of glue the front wheel, adhere「 a fender for front wheel」 to 「the body」.
　　　 （See a photo）

　9. Unify 「the body」 and 「the rear frame」 at 「the connecting part」 and then glue
　　　 the front steel wheel and after that put the rear wheel into 「the rear frame」.

10. Adhere「 a mirror beside a driver's seat」,「 pipe」 behind the seat and 「a roof」for completion

　　　　♦ For the adherence position of the small parts, please refer to the completion picture.


♦ Special attention must be paid when you handle a cutter knife and a sharp instrument. ♦